Engineering, 30.04.2021 20:30 Osorio5116

Consider a simply supported rectangular beam with a span length of 10 ft, a width of 8 in, and an effective depth of 20 in. Normal weight concrete is used for the beam. This beam carries a total factored load of 9.4 kips. The beam is reinforced with tensile steel, which continues uninterrupted into the support. The concrete has a strength of 4000 psi, and the yield strength of the steel is 60,000 psi. Using No. 3 bars and 60,000 psi steel for stirrups, do the followings: a. Identify the locations of the beam that do not need the shear reinforcement.
b. Identify the locations of the beam that can be reinforced with minimum web steel (i. e., with a maximum spacing).
c. What is the required spacing at the location?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 18:20, moneywaydaedae

Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis

Answers: 1

continue

Engineering, 04.07.2019 18:20, kendrawalraven

The characteristic roots of a dynamic system are: 1.7920 1.8160 i, -1.7920 1.8160 i, -0.4160 what is the order of this system? what are the settling time and damping ratio of the system?

Answers: 3

continue

You know the right answer?

Consider a simply supported rectangular beam with a span length of 10 ft, a width of 8 in, and an ef...