subject
Engineering, 28.04.2021 21:00 ejuarez2020

Project: Researching a Local Sustainability Issue Assignment Directions
Your local government is researching the water management in the area. They have called on you as an environmental engineer to explain the current water management methods. You have been asked to describe the methods used by at least two other local areas and suggest the feasibility of adopting a new method. You must research this issue and provide your resources to support your reasoning. You may contact the local governments and find a person to interview, or you may research the issue in magazines or on the Internet. You will submit a three- to five-page report that includes a description of your area's water management methods, information about at least two other nearby areas, and a final analysis with a recommendation for a method. The recommendation may be that no change is made, but you must support your decision with facts and details found in your research.

Assignment Guidelines
Each report must include:

a description of the local area's water management methods
information about at least two other nearby areas’ water management methods
a final analysis with a recommendation
appropriate support including facts and details
a list of resources used for the report
Each analysis must include graphic representation.

Submission Requirements
Three to five pages double spaced
Proper grammar and vocabulary

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, aliceohern
The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite
Answers: 3
image
Engineering, 04.07.2019 18:10, ahmedeldyame
Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.
Answers: 1
image
Engineering, 04.07.2019 18:10, tjeffers90028
Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.
Answers: 1
image
Engineering, 04.07.2019 18:20, jessie8022
Apiston-cylinder device contains 0.1 m3 of liquid water and 0.9 m3 of water vapor in equilibrium at 800 kpa. heat is transferred at constant pressure until the temperature of water reaches 350 °c. determine (a) the quality of water at the initial state (b) the work associated with this process, (c) the heat associated with this process.
Answers: 2
You know the right answer?
Project: Researching a Local Sustainability Issue Assignment Directions
Your local governmen...

Questions in other subjects: