subject
Engineering, 28.04.2021 16:30 LarryJoeseph

A. Your femoral mid-shaft cross-section has a periosteal radius of 12 mm and an endosteal radius of 6mm. Assuming it is a perfectly circular hollow cross section, find the cross-sectional area, cross-sectional moment of inertia, and polar moment of inertia. B. Now assume you fracture your femur at the midshaft and the original bone supports zero stress when the femur is loaded in bending. Assume a perfectly circular callus made of woven bone forms on the periosteal surface. If the bending yield stress of the original healthy cortical bone was 180 MPa, and the outer radius of the woven bone callus is 17 mm, what is the bending yield stress of the woven bone if it supports the same bending moment at yield as the original healthy cortical bone

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, meganwintergirl
Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise
Answers: 3
image
Engineering, 04.07.2019 18:10, selenamr
Ifa component is made of two or more materials with different modulus of elasticity (e), it is called a composite member and we calculate the factor·n". mention the formula for calculating n". also, ifn> 1, explain what will happen to the 1. transformed. gi) ifn 1, what will happen to the material when transformed material when
Answers: 1
image
Engineering, 04.07.2019 18:20, rocio5649
Amixture of slurry and mud is to be pumped through a horizontal pipe of diameter 500 mm. the fluid behaves as a bingham plastic with a yield stress of 30 pa and viscosity 0.04 pa. s. describe the effects of the shear stress through a transverse section of the pipe by plotting the variation in shear stress and velocity profile: (i) just before the slurry starts to move (ii) as the slurry flows when the pressure gradient is double that in part (i)
Answers: 3
image
Engineering, 04.07.2019 19:10, LadyHolmes67
Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false
Answers: 3
You know the right answer?
A. Your femoral mid-shaft cross-section has a periosteal radius of 12 mm and an endosteal radius of...

Questions in other subjects:

Konu
Mathematics, 15.04.2021 17:20
Konu
Social Studies, 15.04.2021 17:20