Engineering, 27.04.2021 14:40 TH3L0N3W0LF

me that both a triaxial shear test and a direct shear test were performed on a sample of dry sand. When the triaxial test is performed, the specimen was observed to fail when the major and minor principal stresses were 100 lb/in2 and 20 lb/in2, respectively. When the direct shear test is performed, what shear strength can be expected if the normal stress is 3000 lb/ft2

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 18:10, hadellolo8839

Acompressor receives the shaft work to decrease the pressure of the fluid. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ijohnh14

Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way

Answers: 2

continue

You know the right answer?

me that both a triaxial shear test and a direct shear test were performed on a sample of dry sand. W...