Engineering, 23.04.2021 15:40 dinadenoirefan

An engineer has invented a new type of 3D printable carbon fiber reinforced polymer. They 3D printed a carbon fiber reinforced bar. The bar has a length of 7.5mm and a cross section area of 5mm^2. They put the bar under uniaxial tensile test and obtained the datasheet (can be found CEE 108, Spring 2021 in the Folder of Week 2 at CCLE). Please (1) determine the linear elastic modulus of this material. (hint: plot the curve, locate the linear section and find the slope of that section). (2) find the elongation at an axial tensile loading of 200N.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, meganwintergirl

Afour cylinder four-stroke in-line engine has a stroke of 160mm, connecting rod length of 150mm, a reciprocating mass of 3kg and its firing order is 1-3-4-2. the spacing between cylinders is 100mm. i. show that the engine is in balance with regard to the primary inertia forces and primary 3. a and secondary inertia couples. li determine the out of balance secondary inertia force ii. propose ways of balancing this out of balance force and discuss the challenges that will arise

Answers: 3

continue

Engineering, 04.07.2019 18:10, jojoangelique13

The flow rate of air through a through a pipe is 0.02 m5/s. a pitot static tube is placed in the flow. the radius of the pitot static tube is 1 mm. assuming the flow to be steady and the air to be at 300k, calculate the difference in total and static pressure if the diameter of the pipe is: (a) d 0.1 m d 0.05 m (c) d 0.01 m

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

You know the right answer?

An engineer has invented a new type of 3D printable carbon fiber reinforced polymer. They 3D printed...