Engineering, 23.04.2021 15:10 malikbryant2002

Q2: The following is a flow chart for a steady state multiple unit process in which 52% of hydrogen entering the membrane is removed in na.
F=10 molls
72
Membrane
20 mol% H,
80 mol% CH4
0.25 mol H,/mol
0.75 mol
CH,/mol
99 mol% H,
1 mol%CH
Y, mol Hj/mol
1-y, mol CH /mol
13
Y mol H/mol
1-y mol CH /mol
Adsorption
Cyclo
πς
0.5 mol H2
99.5 mol CH
a) Calculate the degree of freedom for the membrane, adsorption cycle and the overall
process. And show the order of your calculation
b) Write and simplify the general material balance equation.

Q2: The following is a flow chart for a steady state multiple unit process in which 52% of hydrogen

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, johnthienann58

Thermal stresses are developed in a metal when its a) initial temperature is changed b) final temperature is changed c) density is changed d) thermal deformation is prevented e) expansion is prevented f) contraction is prevented

Answers: 2

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

You know the right answer?

Q2: The following is a flow chart for a steady state multiple unit process in which 52% of hydrogen...