Engineering, 23.04.2021 09:20 laurabwhiddon

Geometry Help please

Select the correct answer from each drop-down menu.

In the figure, all, and both lines are intersected by transversal Complete the statements to prove that m<1=m<5

allb (given)

m21 + m23 = 180° (Linear Pair Theorem)
m25+ m26 = 180° (Linear Pair Theorem)
m21 + m23 = 25+ 26(blank)
m 23 = m26 (blank)
m21 = m 25 (Subtraction Property of Equality

Options (for both blanks)

A) Transitive property of equality quality
B) Alternative interior angles theorem
C) Alternate exterior ankles theorem
D)Vertical angles theorem

Geometry

Help please
Select the correct answer from each drop-down menu.
In the figure, all, and

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, lillygrl100

For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater

Answers: 3

continue

Engineering, 04.07.2019 18:10, colin774

The higher the astm grain size number, the finer the gran is. a)-true b)-false

Answers: 2

continue

Engineering, 04.07.2019 19:10, jimena15

10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.

Answers: 2

continue

Engineering, 04.07.2019 19:10, rhiannpelham60

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

continue

You know the right answer?

Geometry Help please

Select the correct answer from each drop-down menu.

I...