Engineering, 13.04.2021 04:20 jackieespi1461

(a) A non-cold-worked 1040 steel cylindrical rod has an initial length of 100 mm and initial diameter of 7.50 mm. is to be deformed using a tensile load of 18,000 N. It must not experience either plastic deformation or a diameter reduction of more than 1.5 x 10-2 mm. Would the 1040 steel be a possible candidate for this application? Justify your choice(s) using calculations. For the 1040steel: Elastic modulus is 205 GPa, Yield strength is 450 MPa, and Poisson’s ratio is 0.27. (b) If you are asked to perform a strain hardening process to increase the yield strength so the steel can be used in another application with larger force load. How much cold work would be required to reduce the diameter of the steel to 6.0 mm?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:20, CelesteN64

Most leaks in reciprocating air compressors can be detected and minimized by: (clo4) a)-detecting leakage areas using ultrasonic acoustic detector. b)-tightening joints and connections c)-replacing faulty equipment d)-all of the given options

Answers: 2

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

Engineering, 04.07.2019 18:20, miguel454545

Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.

Answers: 1

continue

You know the right answer?

(a) A non-cold-worked 1040 steel cylindrical rod has an initial length of 100 mm and initial diamete...