subject
Engineering, 12.04.2021 23:50 deidrabenson72331

From the list below, select four situations in which casting is the preferred fabrication technique. 1. When the processing would be very precise
2. For large pieces and/or complicated shapes
3. When mechanical strength is not an important consideration
4. For metals having high melting temperatures
5. For alloys having low ductilities
6. When it is the most economical fabrication technique

a. (1), (3), (4), (5)
b. (1), (2), (4), (5)
c. (1), (2), (4), (6)
d. (2), (3), (5), (6)
e. (2), (3), (4), (6)

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
image
Engineering, 04.07.2019 16:10, TheOriginalMeyah
An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)
Answers: 2
image
Engineering, 04.07.2019 18:10, bckyanne3
Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.
Answers: 1
image
Engineering, 04.07.2019 18:10, katelynn73
Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1
Answers: 1
You know the right answer?
From the list below, select four situations in which casting is the preferred fabrication technique....

Questions in other subjects:

Konu
Biology, 06.03.2021 04:30
Konu
Social Studies, 06.03.2021 04:30