Engineering, 12.04.2021 23:00 gumbyseth1969p45qjl
Saturated steam at 1.20bar (absolute)is condensed on the outside ofahorizontal steel pipe with an inside and outside diameter of 0.620 inches and 0.750 inches, respectively. Cooling water enters the tubes at 60.0°F and leaves at 75.0°F at a velocity of 6.00ft/s. (HINT: You may assume laminar condensate flow. You many also assume that the mean bulk temperature of the cooling water is equal to the wall temperature on the outside of the pipe, T".You may also neglect the viscosity correction in your calculations.)a)What are the inside
Answers: 3
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, makaylashrout77
Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.
Answers: 2
Engineering, 03.07.2019 15:10, EmilySerna
Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.
Answers: 1
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10, Candi9697
A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.
Answers: 2
You know the right answer?
Saturated steam at 1.20bar (absolute)is condensed on the outside ofahorizontal steel pipe with an in...
Questions in other subjects:
