subject
Engineering, 08.04.2021 23:40 toricarter00

The 30-min unit hydrograph for an urban catchment is given by Time (min) Runoff (m3 /s) Time (min) Runoff (m3 /s) 0 0.0 210 0.66 30 1.4 240 0.49 60 3.2 270 0.36 90 1.5 300 0.28 120 1.2 330 0.25 150 1.1 360 0.17 180 1.0 390 0.00 The following 120-min storm occurs: Time (min) Rainfall excess (cm) 0-30 2.4 30-60 1.5 60-90 3.1 90-120 2.0 Determine the peak runoff (m3 /s) generated by this 120-min storm..

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:20, moneywaydaedae
Air is compressed isentropically from an initial state of 300 k and 101 kpa to a final temperature of 1000 k. determine the final pressure using the following approaches: (a) approximate analysis (using properties at the average temperature) (b) exact analysis
Answers: 1
image
Engineering, 04.07.2019 18:20, miguel454545
Along 8-cm diameter steam pipe whose external surface temperature is 900c connects two buildings. the pipe is exposed to ambient air at 70c with a wind speed of 50 km/hr blowing across the pipe. determine the heat loss from the pipe per unit length. (b) air at 500c enters a section of a rectangular duct (15 cm x 20 cm) at an average velocity of 7 m/s. if the walls of the duct are maintained at 100c. a) the length of the tube for an exit temperature of the air to be 40 0c. b)the rate of heat transfer from the air. c) the fan power needed to overcome the pressure drop in this section of the duct.
Answers: 1
image
Engineering, 05.07.2019 23:20, neisha2507
Which one of the following faults cause the coffee in a brewer to keep boiling after the brewing cycle is finished? a. an open circuit in the heating element b. a short circuit at the terminals c. welded contacts on the thermostat d. a leak around the gasket
Answers: 3
image
Engineering, 06.07.2019 02:30, emiller6462
Plot schematically the tensile stress versus strain curves for a typical thermoplastic material at a temperature below its glass transition temperature (tg and at a temperature above its tg, respectively. do the same for a typical thermosetting material. list in a table any differences or similarities between the two materials at t> tg and t < tg, respectively, and relate them to the structures of the two types of polymers
Answers: 3
You know the right answer?
The 30-min unit hydrograph for an urban catchment is given by Time (min) Runoff (m3 /s) Time (min) R...

Questions in other subjects:

Konu
Chemistry, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
Physics, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
English, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01
Konu
Mathematics, 09.09.2020 06:01