Engineering, 08.04.2021 17:00 paolaviviana

Question 1 Name some eco-friendly features you might look for while shopping for your first vehicle.
Also, explain techniques you can use while driving any vehicle to increase fuel efficiency and reduce emissions.

Question 2

Your friend wears earbuds while driving to school each day. Is this safe? Is it legal? Explain why or why not.

Question 3

Explain the difference between Personal Injury Protection (PIP) and Property Damage Liability (PDL) insurance.

Question 4

In the event you get pulled over for a traffic stop, describe the situation from the police officer's perspective and list at least two additional things you should do to make the traffic stop go smoothly.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:20, 1230bering

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

continue

You know the right answer?

Question 1 Name some eco-friendly features you might look for while shopping for your first vehicle...