Engineering, 06.04.2021 15:50 hdjsjfjruejchhehd

The device in the above photo is used to check the coolant A. Level

B. Acid level

C. Thickness

D. Temperature

I've found the answer and did the pf test. its B

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, soreese02

An ideal otto cycle with air as the working fluid has a compression ratio of 8. the minimum and maximum temperatures in the cycle are 300 k and 1340 k. use constant specific heats at room temperature to determine (a) the amount of heat transferred to the air during the heat- addition kj/kg, (b) the thermal efficiency, and (c) the thermal efficiency of a carnot cycle ope limits. process, in rating between the same temperature

Answers: 2

continue

Engineering, 04.07.2019 19:10, juneham

Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.

Answers: 2

continue

Engineering, 04.07.2019 19:10, shunna33

Plan an experiment to measure the surface tension of a liquid similar to water. if necessary, review the ncfmf video surface tension for ideas. which method would be most suitable for use in an undergraduate laboratory? what experimental precision could be expected?

Answers: 2

continue

Engineering, 04.07.2019 19:20, diawia

Air at a pressure of 1atm and a temperature of 40 c is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 120 c. the plate has a length of 0.40m (in the flow direction) and a width of 0.15m. the reynolds number based on the plate length is 50, 000. what is the rate of heat transfer from the plate to the air? if the free stream velocity of the air is doubled and the pressure is increased to 10 atm what is the rate of heat transfer?

Answers: 2

continue

You know the right answer?

The device in the above photo is used to check the coolant A. Level

B. Acid level
...