Engineering, 02.04.2021 23:30 bcampos5397

A steam power plant is represented as a heat engine operating between two thermal reservoirs at 800 K and 300 K. The temperature of the steam in the boiler is 550 K and the temperature of the saturated water in the condenser is 330 K. The rates of heat transfer in the boiler and condenser are 4 MW and 2 MW, respectively. Please answer the following. Required:
a. Represent the devices present in the heat engine and include their name along with the data given in the problem.
b. If this steam power plant were to operate as a reversible heat engine, with the boiler and condenser temperatures, what would be its thermal efficiency?
c. Use your result from part (b) to determine if the actual steam power plant can achieve such thermal efficiency. Justify your answer.
d. For the actual steam power plant is the Clausius inequality satisfied? Show you computation and discuss whether your result agrees or disagrees with your answer in part (c).

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, abdirahmansoloman

Air is to be cooled in the evaporator section of a refrigerator by passing it over a bank of 0.8-cm-outer-diameter and 0.4-m-long tubes inside which the refrigerant is evaporating at -20°c. air approaches the tube bank in the normal direction at 0°c and 1 atm with a mean velocity of 4 m/s. the tubes are arranged in-line with longitudinal and transverse pitches of sl- st 1.5 cm. there are 30 rows in the flow direction with 15 tubes in each row. determine (a) the refrigeration capacity of this system and (b) pressure drop across the tube bank. evaluate the air properties at an assumed mean temperature of -5°c and 1 atm. is this a good assumption?

Answers: 1

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 19:10, netflixacc0107

What is the major difference between thermoplastics and thermosetting plastics from the polymerization structure point of view?

Answers: 2

continue

You know the right answer?

A steam power plant is represented as a heat engine operating between two thermal reservoirs at 800...