Engineering, 29.03.2021 19:30 Maaaryyss

A workpiece in the form of a bar 100 mm in diameter is to be turned down to 70 mm diameter for 50 mm of its length. A roughing cut using maximum power and a depth of cut of 12 mm is to be followed by a finishing cut using a feed of 0.1 mm and a cutting speed of 1.5 m/s. It takes 20 s to load and unload the workpiece and 30 s to set the cutting conditions, set the tool at the beginning of the cut and engage the feed. The specific cutting energy for the material is 2.3 GJ/m3 and the lathe has a 3-kW motor and a 70 percent efficiency. Estimate:

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, aliceohern

The y form of iron is known as: a) ferrite b) cementite c) perlite d) austenite

Answers: 3

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, Strick1530

Which of the following components of a pid controlled accumulates the error over time and responds to system error after the error has been accumulated? a)- proportional b)- derivative c)- integral d)- on/off.

Answers: 2

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

You know the right answer?

A workpiece in the form of a bar 100 mm in diameter is to be turned down to 70 mm diameter for 50 mm...