Engineering, 29.03.2021 09:30 almostnevercbbc

The average wind velocity in a particular area is found to be 5.5m/s. It is proposed to install a wind driven turbine with a blade radius of 1.8m. The

proposed design has an interference factor of 0.21 and a torque coefficient of 0.8.

Determine:

a) The expected power output of the turbine.

b) Thrust on the turbine.

c) Torque on the turbine.

d) Rotational speed.

Note: Assuming the air density is 1.2 kg/m3

The average wind velocity in a particular area is found to be 5.5m/s. It is

proposed to install a

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, xboxdude06

Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:20, alexis9263

Have a greater impact on maintenance productivity than any other support group. (clo5) a)-the top management b)-inventory and purchasing c)-sub-contracting d)-cmms

Answers: 2

continue

Engineering, 04.07.2019 18:20, dlr1628

Acertain flow of air (at stp) has a velocity distribution given by v i (in ft/s). if this flow is going through a 4 ft square area in the yz-plane (centered at the origin), what is the mass flow rate (in lbm/s)?

Answers: 2

continue

You know the right answer?

The average wind velocity in a particular area is found to be 5.5m/s. It is proposed to install a w...