Engineering, 28.03.2021 20:50 woodpeckerdeejpe8wvh

The crank of a slider crank mechanism is 15 cm and the connecting rod is 60 cm long. The crank makes 250 r. p.m in the clockwise direction. When it has turned an angle of 210 ϕ from the inner dead center (I. D.C) position, graphically determine:

a. Velocity of slider C

b. Angular velocity of connecting rod and

c. Linear velocity of the mid-point of the connecting rod (D).

d. Use complex number and instant center methods to check the results.

2. From the result of parts 1, graphically determine:

a. Acceleration of point C

b. Angular acceleration of connecting rod CB

The crank of a slider crank mechanism is 15 cm and the connecting rod is 60 cm long. The crank make

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, safiyabrowne7594

Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?

Answers: 3

continue

Engineering, 04.07.2019 18:20, AnonymousLizard52303

A2-m rigid tank initially contains saturated water vapor at 100 kpa. the tank is connected to a supply line through a valve. steam is flowing in the supply line at 600 kpa and 300 c. the valve is opened, and steam is allowed to enter the tank until the pressure in the tank reaches the line pressure, at which point the valve is closed. a thermometer placed in the tank indicates that the temperature at the final state is 200°c. determine (a) the mass of steam that has entered the tank (b) the amount of heat transfer.

Answers: 3

continue

Engineering, 06.07.2019 03:10, LouieHBK

Different between right hand turning tool and left hand turning tool ?

Answers: 1

continue

Engineering, 06.07.2019 03:20, crazylife77

What is the strain energy stored in a solid uniformly circular shaft of length 3.0 m and diameter 120 mm when subject to pure torsion if the maximum shear stress is 40 mpa? g-80gpa

Answers: 1

continue

You know the right answer?

The crank of a slider crank mechanism is 15 cm and the connecting rod is 60 cm long. The crank makes...