Engineering, 27.03.2021 14:10 biancabell3

Air flows adiabatically in a converging duct, which is fed from a large reservoir where the temperature and the pressure are 305 K and 210 kPa, respectively. At the end of the duct,
where the cross-sectional area is 0.0025 the pressure and temperature are 172 kPa and
278 K, respectively, Determine the Mach number at the end of the duct and find the mass
flow rate.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, namira16

Which of the following controllers anticipates the future from the slope of errors over time? a)-proportional b)-on/off c)-integral d)-derivative.

Answers: 2

continue

Engineering, 04.07.2019 18:10, oshawn108

Ahot wire operates at a temperature of 200°c while the air temperature is 20°c. the hot wire element is a tungsten wire of 5 um diameter and 2 mm in length. plot using excel current, heat transfer and heat generated by the wire for air velocity varying from 1-10 m/s in steps of lm/s? matlab the sensor voltage output, resistance, or assume nu 0.989 re033pr13 take air properties at tr (200°c20°c)/2 = 110°c properties of tungsten: c 0.13 kj/kg. k 3 p 19250 kg/m k (thermal conductivity) = 174 w/m. k

Answers: 2

continue

You know the right answer?

Air flows adiabatically in a converging duct, which is fed from a large reservoir where the tempera...