Engineering, 27.03.2021 14:00 chris3633

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitude equal to 10 volt and frequency of 100 kHz. It is found that the power of the double side band represents the entire power of the bandpass signal. Answer the following: 1-According to the given information, what is the type of the modulation?
2-The total power of the bandpass signal : (Please write a number without units)
3-If the bandpass signal is applied on the input of a synchronous detector, then what is the value of the power of the output signal? (Please write a number without units)

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitu

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 04.07.2019 18:20, maustin5323

Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]

Answers: 1

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

Engineering, 04.07.2019 18:20, samueltaye

Modern high speed trains do not have perpendicular expansion gaps where rails are joined end-to-end any more they are mostly welded together but what might happen if there was a spell of particularly hot weather that causes inspection of the tracks?

Answers: 1

continue

You know the right answer?

Q5/ A message signal with power equal to 0.5 watt is used to modulate a carrier signal with amplitud...