Engineering, 25.03.2021 21:30 TamB01
500 gallon per minute of water flows through 300 ft of 6 in steel pipe at temperature of 100 degrees F. The pipe contains two 6 in steel elbows, two fully open gate valves, a fully open 90 o angle valve, and a swing check valve. If the discharge end of the pipe is located 10 ft higher than the entrance, what is the pressure difference between the two ends of the pipe
Answers: 1
Other questions on the subject: Engineering
Engineering, 04.07.2019 18:20, ashleyjaslin
Derive the correction factor formula for conical nozzle i=-(1+ cosa) and calculate the nozzle angle correction factor for a nozzle whose divergence hal-fangle is 13 (hint: assume that all the mass flow originates at the apex of the cone.
Answers: 3
Engineering, 04.07.2019 18:20, rjone8429
Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency
Answers: 1
Engineering, 04.07.2019 18:20, RiverH246
Air flows over a heated plate àt a velocity of 50m/s. the local skin factor coefficient at a point on a plate is 0.004. estimate the local heat transfer coefficient at this point. the following property data for air are given: density = 0.88kg/m3 , viscosity 2.286 x 10 ^-5 kgm/s , k = 0.035w/mk ,cp = 1.001kj/kgk. use colburn reynolds analogy.
Answers: 1
You know the right answer?
500 gallon per minute of water flows through 300 ft of 6 in steel pipe at temperature of 100 degrees...
Questions in other subjects:
Chemistry, 26.03.2020 16:57
