subject
Engineering, 22.03.2021 20:30 crystalbyrd79p8imrx

A helicopter gas turbine requires an overall compressor pressure ratio of 10:1. This is to be obtained using a two-spool layout consisting of a four-stage Z02 Gas Turbine Theory 93093.indd 578 27/04/2017 07:21 APPENDIX B PROBLEMS 579 axial compressor followed by a single-stage centrifugal compressor. The polytropic efficiency of the axial compressor is 92 per cent and that of the centrifugal is 83 per cent. The axial compressor has a stage temperature rise of 30 K, using a 50 per cent reaction design with a stator outlet angle of 208. If the mean diameter of each stage is 25.0 cm and each stage is identical, calculate the required rotational speed. Assume a work-done factor of 0.86 and a constant axial velocity of 150 m/s. Assuming an axial velocity at the eye of the impeller, an impeller tip diameter of 33.0 cm, a slip factor of 0.90 and a power input factor of 1.04, calculate the rotational speed required for the centrifugal compressor. Ambient conditions are 1.01 bar and 288 K. [Axial compressor 318 rev/s, centrifugal compressor 454 rev/s]

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 06.07.2019 03:20, 1xXJOKERXx3
Areaction-bonded silicon nitride ceramic has a strength of 250 mpa and a fracture toughness of 3.4 mpa(m)^1/2, what is the largest-sized internal flaw that this material can support without fracturing? (use y -1 in the fracture-toughness equation.)
Answers: 3
image
Engineering, 06.07.2019 03:30, sipstick971
An ammonia compressor has a 5% clearance volume and displacement rate of 80 l/s and pumps against a condensing temperature of 40°c. for two different temperatures of -10°c and 10°c, compute the mass flow rate of refrigerant assuming the clearance volumetric efficiency applies. discharge specific volume corresponding to-10°c and 10°c are 112.5 l/kg and 95 l/kg, respectively.
Answers: 2
image
Engineering, 06.07.2019 03:30, aksambo4707
State the stress optic law in two dimension and obtain an expression for the same.
Answers: 2
You know the right answer?
A helicopter gas turbine requires an overall compressor pressure ratio of 10:1. This is to be obtain...

Questions in other subjects:

Konu
Computers and Technology, 06.09.2019 08:10