Engineering, 22.03.2021 16:10 ladybugys

2. In order for an airplane to remain in level, steady flight, what must happen to the four forces? 3. Describe the relationship between the total lift, vertical component of lift and weight during the following maneuvers:

Aircraft banks at a constant altitude

After take-off, the aircraft executes a climbing turn

Aircraft is in a descending turn to align with the runway

4. If the mass remains constant and the force changes, what happens to the acceleration of an object?

5. If the force remains constant and the mass changes, what happens to the acceleration of that object?

6. What effect does air have on the acceleration of aircraft during flight?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, sarahgrindstaff123

Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.

Answers: 2

continue

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

You know the right answer?

2. In order for an airplane to remain in level, steady flight, what must happen to the four forces?...