Engineering, 21.03.2021 09:40 fbr45508

Question#01 a) Write a comprehensive note on cooling load calculation, elaborating the following.

1- Room sensible heat, effective room sensible heat and total sensible heat.

2- Room latent heat, effective room latent heat and total latent heat.

3- Grand total heat

b) Write a comprehensive note describing the selection of a suitable system (VRV/VRF system, Package system or Chilled Water System) for the following.

1- Office building with a total cooling load of 50 tons.

2 -A three story existing residential building consisting of various spaces with a total cooling load of 150 tons.

3- A seven story hospital building with a total cooling load of 1500 tons.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, Larkinlover703

Items are similar to the free issue items, but their access is limited. (clo5) a)-bin stock items free issue b)-bin stock controlled issue c)-critical or insurance spares d)-rebuildable spares e)-consumables

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, luisgonz5050

Find the kinematic pressure of 160kpa. for air, r-287 j/ kg k. and hair al viscosity of air at a temperature of 50°c and an absolute (10 points) (b) find the dynamic viscosity of air at 110 °c. sutherland constant for air is 111k

Answers: 3

continue

Engineering, 04.07.2019 19:10, thawkins79

Agas contained within a piston-cylinder assembly e end nation about same energy states, 1 and 2, where pi 10 bar, v undergoes two processes, a and b, between the sam 0.1 m3, ui-400 kj and p2 1 bar, v2 1.0 m2, u2 200 kj: process a: process from 1 to 2 during which the pressure- volume relation is pv constant process b: constant-volume process from state 1 to a pressure of 2 bar, followed by a linear pressure-volume process to +20 0 state 2 kinetic and potential energy effects can be ignored. for each of the processes a and b, (a) sketch the process on p-v coordinates, (b) evaluate the work, in kj, and (c) evaluate process the heat transfer, in kj

Answers: 2

continue

You know the right answer?

Question#01 a) Write a comprehensive note on cooling load calculation, elaborating the following.