Engineering, 19.03.2021 04:00 zitterkoph
A 15cm x 20cm printed circuit board is to be cooled by passing cool air through a 20 cm long channel of rectangular cross section 0.2 cm x 14 cm drilled into the board. The heat generated by the electronics components is conducted across the thin layer of the board to the channel where it is removed by air that enters the channel at 15oC. The heat flux at the top surface of the channel can be considered to be uniform and heat transfer through other surfaces is negligible. If the velocity of the air at the inlet of the channel is not to exceed 4m/s and the surface temperature of the channel is to remain under 50oC, determine the maximum total power of the electronic components that can safely be counted on this circuit board.
Answers: 1
Engineering, 03.07.2019 23:20, abbz13
Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct
Answers: 3
Engineering, 04.07.2019 18:10, ashleybaber4966
If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79
Answers: 1
Engineering, 04.07.2019 18:10, agpraga23ovv65c
Carbon dioxide gas expands isotherm a turbine from 1 mpa, 500 k at 200 kpa. assuming the ideal gas model and neglecting the kinetic and potential energies, determine the change in entropy, heat transfer and work for each kilogram of co2.
Answers: 2
A 15cm x 20cm printed circuit board is to be cooled by passing cool air through a 20 cm long channel...
History, 30.03.2020 02:01
Mathematics, 30.03.2020 02:01
Social Studies, 30.03.2020 02:01
History, 30.03.2020 02:01
Geography, 30.03.2020 02:01