Engineering, 18.03.2021 02:20 rakanmadi87

Air enters a compressor at 100 kPa and 27 oC and exits at 700 kPa and 227 oC. The compressor is adiabatic and the volumetric flow rate at the exit of the compressor is 17 L/s. For this compressor changes in kinetic and potential energies are negligible. If the compressor operates at steady state, find the input power to the compressor in kW.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, keigleyhannah30

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 19:10, gabigalvis1091

What is the main objective of using reheat rankine cycle?

Answers: 3

continue

Engineering, 04.07.2019 19:10, rhiannpelham60

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

continue

You know the right answer?

Air enters a compressor at 100 kPa and 27 oC and exits at 700 kPa and 227 oC. The compressor is adia...