Engineering, 18.03.2021 01:40 aliopqwas

A DC power supply is formed of an ideal transformer feeding an ideal AC/DC full bridge SCR rectifier. The transformer input is at 120VRMS, and the rectifier nominal output is 24V. The input can fluctuate between 119VRMS and 122.1 VRMS, and the output voltage thus fluctuates between - 0.25% and 0.7% from the nominal voltage, respectively. The load is resistive and can also vary between 20W and 200W where the output voltage for this load range fluctuates between 23.9V and 23.6V, respectively. 1) (8 points) Find the line and load regulation of this power supply.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, EmilySerna

Heat is added to a piston-cylinder device filled with 2 kg of air to raise its temperature 400 c from an initial temperature of t1 27 cand pressure of pi 1 mpa. the process is isobaric process. find a)-the final pressure p2 b)-the heat transfer to the air.

Answers: 1

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:20, rbgrh9465

An open feedwater heater operates at steady state with liquid entering at inlet 1 with t? = 40°c and pl = 1 .2 mpa. water vapor att2-200°c and p2 = 1.2 mpa enters at inlet 2. saturated liquid water exits with a pressure of pa 1.2 mpa. neglect heat transfer with the surroundings and all kinetic and potential energy effects, determine the mass flow rate of steam at inlet 2 if the mass flow rate of liquid water at inlet 1 is given as 2 kg/s.

Answers: 3

continue

You know the right answer?

A DC power supply is formed of an ideal transformer feeding an ideal AC/DC full bridge SCR rectifier...