Engineering, 12.03.2021 15:30 zanaplen27

A 5.6L V8 CI engine has a compression ratio of 20.0and a crevice volume of 5% of clearance volume. During the engine cycle, crevice volume pressure equals combustion chamber pressure while remaining at the cylinder wall temperature of180C. Cylinder conditions at the startof compression are 60C and 140 kPa and peaktemperature is 12,000 kPa. Cutoff ratio is 2.2. Calculate:1.Crevice volume of one cylinder2.Percent of air-fuel mixture in thecrevice volume at the end of compression3.Percent of air-fuel mixture in the crevice volume at the end of combustion

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, breannaasmith1122

Two flowing streams of argon gas are adiabatically mixed to form a single flow/stream. one stream is 1.5 kg/s at 400 kpa and 200 c while the second stream is 2kg/s at 500 kpa and 100 ? . it is stated that the exit state of the mixed single flow of argon gas is 150 c and 300 kpa. assuming there is no work output or input during the mixing process, does this process violate either the first or the second law or both? explain and state all your assumptions.

Answers: 1

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

Engineering, 04.07.2019 18:20, krojas015

Asolid cylinder is concentric with a straight pipe. the cylinder is 0.5 m long and has an outside diameter of 8 cm. the pipe has an inside diameter of 8.5 cm. the annulus between the cylinder ad the pipe contains stationary oil. the oil has a specific gravity of 0.92 and a kinematic viscosity of 5.57 x 10-4 m2/s. most nearly, what is the force needed to move the cylinder along the pipe at a constant velocity of 1 m/s?

Answers: 3

continue

Engineering, 04.07.2019 19:10, LadyHolmes67

Apressure vessel with an r/t 20 cannot be treated as thin walled vessel. a)-trune b)- false

Answers: 3

continue

You know the right answer?

A 5.6L V8 CI engine has a compression ratio of 20.0and a crevice volume of 5% of clearance volume. D...