Engineering, 12.03.2021 15:00 ilpark0125

) A regenerative vapor power cycle has three turbine stages with steam entering the first stage at 2500 lbf/in2 , 1100 o F. The cycle has two feedwater heaters, a closed feedwater heater using extracted steam at 500 lbf/in2 and an open feedwater heater operating at 50 lbf/in2 . Saturated liquid condensate drains from the closed feedwater heater at 500 lbf/in2 and passes through a trap into the open heater. The feedwater leaves the closed heater at 2500 lbf/in2, 478 o F. Saturated liquid leaves the open heater at 50 lbf/in2 and the condenser pressure is 1 lbf/in2 . For isentropic operation of the turbines and pumps, determine the efficiency of this cycle.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, DestyHilBan1183

Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.

Answers: 3

continue

Engineering, 04.07.2019 18:10, bckyanne3

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Fahaddie

The thermal expansion or contraction of a given metal is a function of the f a)-density b)-initial temperature c)- temperature difference d)- linear coefficient of thermal expansion e)- final temperature f)- original length

Answers: 2

continue

Engineering, 04.07.2019 18:10, QueenLife4869

Awall of 0.5m thickness is to be constructed from a material which has average thermal conductivity of 1.4 w/mk. the wall is to be insulated with a material having an average thermal conductivity of 0.35 w/mk so that heat loss per square meter shall not exceed 1450 w. assume inner wall surface temperature of 1200°c and outer surface temperature of the insulation to be 15°c. calculate the thickness of insulation required.

Answers: 3

continue

You know the right answer?

) A regenerative vapor power cycle has three turbine stages with steam entering the first stage at 2...