Engineering, 08.03.2021 23:30 womankrush538

A wide flange steel beam shown in the figure below supports a permanent concrete masonry wall, floor slab, architectural finishes, mechanical and electrical systems. Determine the uniform dead load in
KN per linear meter acting on the beam. The wall is 2.8 m high, non-load bearing and laterally braced at
the top to upper floor framing (not shown). The wall consists of 250 mm. lightweight reinforced concrete
masonry units with an average weight of 4.31 KN/m2
. The composite concrete floor slab construction spans
over simply supported steel beams, with a tributary width of 3 m, and weighs 2.4 KN/m2
. The estimated
uniform dead load for structural steel framing, fireproofing, architectural features, floor finish, and ceiling
tiles equals 1.15 KN/m2
, and for mechanical ducting, piping, and electrical systems equals 0.29 KN/m2
.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, ahmedeldyame

Aloaded platform of total mass 500 kg is supported by a dashpot and by a set of springs of effective stiffness 72 kn/m. it is observed that when the platform is depressed through a distance x = 12.5 cm below its equilibrium position and then released without any initial velocity; it reaches its equilibrium position in the shortest possible time without overshoot. find the position and velocity of the loaded platform 0.10 sec. after its release. if a further load of 400 kg is added to the platform, find, i) the frequency of damped vibrations, and i) the amplitude of vibration after 2 complete oscillations, given that the initial amplitude is 15 cm.

Answers: 1

continue

Engineering, 04.07.2019 18:10, Tyrant4life

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.

Answers: 1

continue

Engineering, 04.07.2019 18:20, 1230bering

Select any two (2) areas of applications of chain-drive. (clo4) a)-permanent lubrication necessary b)-hydraulic forklift truck operation c)-rigging and heavy moving materials d)-relatively high maintenance costs e)-costlier than belt drives

Answers: 2

continue

Engineering, 04.07.2019 18:20, samantha636

Avolume of 2.65 m3 of air in a rigid, insulated container fitted with a paddle wheel is initially at 264 k, 5.6 bar. the air receives 432 kj by work from the paddle wheel. assuming the ideal gas model with cv = 0.71 kj/kg • k, determine for the air the amount of entropy produced, in kj/k

Answers: 2

continue

You know the right answer?

A wide flange steel beam shown in the figure below supports a permanent concrete masonry wall, floo...