Engineering, 08.03.2021 22:40 shaylaahayden45061

Engine oil flows at a rate of 1 kg/s through a 5-mmdiameter straight tube. The oil has an inlet temperature of 45 C and it is desired to heat the oil to a mean temperature of 80 C at the exit of the tube. The surface of the tube is maintained at 150 C. Determine the required length of the tube. Hint: Calculate the Reynolds numbers at the entrance and exit of the tube before proceeding with your analysi

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, mm016281

What difference(s) did you notice using a pneumatic circuit over hydraulic circuit. explain why the pneumatic piston stumbles when it hits an obstacle.

Answers: 2

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

Engineering, 04.07.2019 18:10, wirchakethan23

Hydraulic fluid with a sg. of 0.78 is flowing through a 1.5 in. i. d. pipe at 58 gal/min. the fluid has an absolute viscosity of 11.8 x 105 lbf-sec/ft2. is the flow laminar, turbulent or within the critical range? give both a numerical reynolds number and a term answer.

Answers: 3

continue

Engineering, 04.07.2019 18:10, oliviasoreo92

Compute the pressure drop of 30°c air flowing with a mean velocity of 8 m/s in a circular sheet-metal duct 300 mm in diameter and 15 m long. use a friction factor, f 0.02, and pair = 1.1644 kg/m a. 37.26 pa b. 25.27 pa n c. 29.34 pa d. 30.52 pa

Answers: 1

continue

You know the right answer?

Engine oil flows at a rate of 1 kg/s through a 5-mmdiameter straight tube. The oil has an inlet temp...