Engineering, 02.03.2021 19:20 autumnplunkett09
While recharging a refrigerant system, the charging stops before the required amount of refrigerant has been inserted. What should a technician do at this time?
A) start the engine and charge through the high side
B) open the low side valve to allow charging through both sides
c) start the engine and charge through the low side
d) reevacuate and recharge the system again
Answers: 1
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
Engineering, 04.07.2019 18:20, maustin5323
Athin walled concentric tube exchanger is used to cool engine oil from 160°c to 60°c with water that is available at 25°c acting as a coolant. the oil and water flow rates are each at 2 kg/s, and the diameter of the inner tube is 0.5 m and the corresponding value of the overall heat transfer coefficient is 250 w/m2. oc. how long must the heat exchanger be to accomplish the desired cooling? cpwater=4.187 kj/kg-candcpengine el=2.035 kj/kg·°c, oil . 120]
Answers: 1
Engineering, 04.07.2019 18:20, 21megoplin
How much power could a wind turbine produce if it had the following specifications? cp = 0.45 -d=1.2kg/m3 d=50m v 5m/s
Answers: 2
While recharging a refrigerant system, the charging stops before the required amount of refrigerant...
Mathematics, 01.09.2021 06:00
Mathematics, 01.09.2021 06:00
Mathematics, 01.09.2021 06:00
Mathematics, 01.09.2021 06:00
Social Studies, 01.09.2021 06:00