Engineering, 28.02.2021 08:20 makayyafreeman

What is a “V speed”? Why are “V speeds” important? Ans:
Describe the ALTIMETER. How does it work and what does it measure? What is the Kohlsman window? Why must we regularly adjust the Kohlsman setting?
Ans:
1Describe the effects of “non-standard” atmospheric temperature on altimeter accuracy.
Ans:
What is pressure altitude?
Ans:
What is density altitude?
Ans:
What does the vertical speed indicator (VSI) tell us?
Ans:
What does the VSI measure?
Ans:
What is an IVSI? What makes it different from a basic VSI and WHY do we use them on high altitude aircraft?
Ans:
What is a GYROSCOPE? What property does a gyroscope demonstrate while spinning that makes it useful to us?
Ans:
That is gyroscopic precession? How does it act on a spinning mass?
Ans:
Describe an attitude indicator. What does it tell us? Does it indicate whether or not we are TURNING (be careful here)?
Ans:
Describe the TURN COORDINATOR. What does it tell us? What is a “standard rate turn”?
Ans:
Describe the typical aircraft magnetic compass. What does it indicate?
Ans:
What inherent errors are associated with the magnetic compass in an aircraft?
Ans:

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 15:10, theamandawhite

Ahouse has the following electrical appliance usage (1) single 40w lamp used for 4 hours per day (2) single 60w fan used for 12 hours per day (3) single 200w refrigerator that runs 24 hours per day with compressor run 12 hours and off 12 hours find the solar power inverter size in watt with correction factor of 1.25.

Answers: 1

continue

Engineering, 04.07.2019 19:10, santosbeti90

With increases in magnification, which of the following occur? a. the field of view decreases. b. the ambient illumination decreases. c. the larger parts can be measured. d. the eyepiece must be raised.

Answers: 1

continue

Engineering, 04.07.2019 19:10, rhiannpelham60

The maximum shear stress and maximum flexural stress occur at the same location along a beam subjected to a non-uniform bending load. a)-trune b)- false

Answers: 2

continue

Engineering, 04.07.2019 19:20, holaadios222lol

Apiping systems consists of 6 m of 6-std type k and 12 m of 4-std type k, both drawn copper tubing. the system conveys ethylene glycol at a rate of 0.013 m3/s. the pressure drop across the system is to be calculated. there are two 90° elbows in the 6-in pipe, a reduction from the 6-in pipe to the 4-in pipe and four 90° elbows in the 4-in pipe. all fittings are soldered (same as flanged) and regular. the inlet and outlet of the system are at the same height.

Answers: 1

continue

You know the right answer?

What is a “V speed”? Why are “V speeds” important? Ans:
Describe the ALTIMETER. How does it w...