subject
Engineering, 22.02.2021 18:50 dianaskye9081

The following data are obtained when open circuit and short circuit tests are performed on a single phase, 50 kVA, 2400/240 Volt 50 HZ distribution transformer. VOLTAGE(volts)CURRENT (amperes) POWER (watts) 213 Measurement in low voltage side with high voltage winding open Measurement on high voltage side with low voltage winding shorted 240 5.97 60 20.8 750 (a) Neglecting the series impedance, determine the exciting admittance referred to the high voltage side.
(b) Neglecting the exciting admittance, determine the equivalent series impedance referred to the high voltage side
(c) Assuming equal series impedances for the primary and referred secondary, obtain an equivalent T-Circuit referred to the high voltage side.

ansver
Answers: 2

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, ijohnh14
Shafts are machine elements that are used to a) carry axial loads b) direct shear loads c) transmit power d) rotate at constant speed e) none of the above circular and square shafts subjected to the same torque under the same circum behave a) the same way b) almost the same way
Answers: 2
image
Engineering, 04.07.2019 18:20, safiyabrowne7594
Ahe-xe mixture containing a 0.75 mole fraction of helium is used for cooling electronics in an avionics application. at a temperature of 300 k and atmospheric pressure, calculate the mass fraction of helium and the mass density, molar concentration and molecular weight of the mixture. if the cooling capacity is 10 l, what is the mass of the coolant?
Answers: 3
image
Engineering, 04.07.2019 19:10, juneham
Estimate the change in specific internal energy au and specific enthalpy h from inlet to outlet for ethylene glycol (a liquid) flowing through each of the following devices: (a) a heat exchanger where the glycol temperature increases from 20 °c to 80 °c; (b) a pump operating at about 25 °c and increasing the glycol pressure from 100 kpa to 8 mpa.
Answers: 2
image
Engineering, 04.07.2019 19:10, nani3906
Starting wih an energy balance on a rectangular volume element, derive the one- dimensional transient heat conduction equation for a plane wall with constant thermal conductivity and no heat generation.
Answers: 1
You know the right answer?
The following data are obtained when open circuit and short circuit tests are performed on a single...

Questions in other subjects: