Engineering, 19.02.2021 01:00 chocolate4550

Exam Lesson Name: Introduction to CAD Technology Exam number: 502016RR
Exam Guidelines
Exam Instructions
Question 1 of 20
Select the best answer for the question
1. If designers are concerned that an insulated component might lose too much heat through one of its sides, they could subject its CAD files to a
O A. kinematic analysis.
O B. thermal analysis.
O C. field analysis.
OD. modal analysis.
Mark for review (Will be highlighted on the review page)

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, heidiburgos1own6c0

Fluids at rest possess no flow energy. a)- true b)- false

Answers: 3

continue

Engineering, 04.07.2019 18:10, tjeffers90028

Refrigerant 134a enters an insulated compressor operating at steady state as saturated vapor at -26°c with a volumetric flow rate of 0.18 m3/s. refrigerant exits at 9 bar, 70°c. changes in kinetic and potential energy from inlet to exit can be ignored. determine the volumetric flow rate at the exit, in m3/s, and the compressor power, in kw.

Answers: 1

continue

Engineering, 04.07.2019 18:10, leomessifanboy678

The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody

Answers: 2

continue

Engineering, 04.07.2019 18:20, esmemaluma00

Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um

Answers: 2

continue

You know the right answer?

Exam Lesson Name: Introduction to CAD Technology Exam number: 502016RR
Exam Guidelines
...