Engineering, 18.02.2021 23:30 ElPaisaJuan

PLEASE HELP, THIS IS A WOODSHOP QUESTION THAT I DON'T UNDERSTAND!! Today we selected our walnut. We laid out the cuts to be made by checking to see if 4 pieces could be cut out of the big, rough stock board. The rough stock board was 8 3/4" wide, the pieces we need to cut are: 1-3/4", 1-3/4", 1-3/4", 2+". if for every table saw cut we make we lose 1/8" (extra woodcut off during cutting for the saw blade kerf) how much wood is leftover for if we make 3 cuts? (the exact size of the 2+" piece that remains?

How much is left over if our milled stock is 8-11/16" wide?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 16:10, Arealbot

The force on a cutting tool are 2600n vertically downward and 2100 horizontal. determine the resultant force acting on the tool and the angle at which it acts.

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, katelynn73

Atmospheric air has a temperature (dry bulb) of 80° f and a wet bulb temperature of 60° f when the barometric pressure is 14.696 psia. determine the specific humidity, grains/lb dry air. a. 11.4 c. 55.8 d. 22.5 b. 44.1

Answers: 1

continue

You know the right answer?

PLEASE HELP, THIS IS A WOODSHOP QUESTION THAT I DON'T UNDERSTAND!! Today we selected our walnut. We...