subject
Engineering, 12.02.2021 16:20 campilk5

Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoir B. The surface area of A is half of B. The area of B is 40 km2. Both reservoirs A and B are subject to a total rainfall of 50 cm and evaporation of 30 cm on an annual basis. To preserve the ecological environment in the riparian zone along the water course, reservoir A is required to release a constant flow of 0.1 m3/s to reservoir B, whereas reservoir B releases 0.3 m3/s to its downstream channel. At the present time, other than the in-stream flow requirement, there is no manmade structure withdrawing water from reservoir B. A small town of 50 000 is located near reservoir B. The per capita water consumption is 400 liters per day. The town is contemplating to use reservoir B as a water supply reservoir. a) Determine the annual water storage change of water (in cm) in each of the two reservoirs if water is to be delivered from reservoir B to satisfy the water consumption stipulated above.
b) To maintain the required in-stream flow requirement and per-capita consumption as stipulated above, for how long can this reservoir supply water to the town?
c) If the annual water storage change in reservoir B cannot be negative, how much of the percapita consumption has to be adjusted?

ansver
Answers: 1

Other questions on the subject: Engineering

image
Engineering, 03.07.2019 14:10, BardiFan
Amass of m 1.5 kg of steam is contained in a closed rigid container. initially the pressure and temperature of the steam are: p 1.5 mpa and t 240°c (superheated state), respectively. then the temperature drops to t2= 100°c as the result of heat transfer to the surroundings. determine: a) quality of the steam at the end of the process, b) heat transfer with the surroundings. for: p1.5 mpa and t 240°c: enthalpy of superheated vapour is 2900 kj/kg, specific volume of superheated vapour is 0. 1483 m/kg, while for t 100°c: enthalpy of saturated liquid water is 419kj/kg, specific volume of saturated liquid water is 0.001043m/kg, enthalpy of saturated vapour is 2676 kj/kg, specific volume of saturated vapour is 1.672 m/kg and pressure is 0.1 mpa.
Answers: 3
image
Engineering, 04.07.2019 18:10, michellerosas
Ajournal bearing has a journal diameter of 3.250 in with a unilateral tolerance of 20.003 in. the bushing bore has a diameter of 3.256 in and a unilateral tolerance of 0.004 in. the bushing is 2.8 in long and supports a 700-lbf load. the journal speed is 900 rev/min. find the minimum oil film thickness and the maximum film pressure for both sae 20 and sae 20w-30 lubricants, for the tightest assembly if the operating film temperature is 160°f. a computer code is appropriate for solving this problem.
Answers: 3
image
Engineering, 04.07.2019 18:10, leomessifanboy678
The filament of an incandescent lamp has a temperature of 2000k. calculate the fraction of radiation emitted in the visible light band if the filament is approximated as blackbody
Answers: 2
image
Engineering, 04.07.2019 18:10, redrosesxx
Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux
Answers: 3
You know the right answer?
Consider two reservoirs, A and B, connected in series with reservoir A situated upstream of reservoi...

Questions in other subjects:

Konu
Mathematics, 16.03.2022 14:00