Engineering, 08.02.2021 18:50 rrrrainy
A city wants to install a reactor for the removal of contaminants. The current concentration of the contaminants in the effluent is 150 mg/L and the design flow rate is 100 gal/min. The contaminant removal rate is studied in a batch process to estimate how fast the system remove contaminants. The following data is obtained.
Time (hours) Concentration (ppm)
0 50.8
7.5 32
15 19.7
22.5 12.3
30 7.6
You are asked to determine the size (i. e, volume) of the reactor that will be needed to reduce the concentration of the contaminant to 25 mg/L. Determine this for:
A) A plug flow reactor.
B) A completely mixed reactor.
C) Three CSTR reactors in series (same dimensions, find the individual reactor volume and total volume).
Answers: 1
Other questions on the subject: Engineering
Engineering, 03.07.2019 14:10, kayabwaller4589
When at a point two solid phase changes to one solid phase on cooling then it is known as a) eutectoid point b) eutectic point c) peritectic point d) peritectoid point
Answers: 3
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
You know the right answer?
A city wants to install a reactor for the removal of contaminants. The current concentration of the...
Questions in other subjects:
Mathematics, 15.06.2021 01:50
Computers and Technology, 15.06.2021 01:50
Mathematics, 15.06.2021 01:50
