Engineering, 07.02.2021 19:50 jstephanie644
A technician is setting up a lab scope to measure a sensor. Technician A says that the vertical voltage scale must be adjusted in relation to the expected voltage signal. Technician B says the trigger slope must be set to positive if the trace begins with a rising voltage. Who is correct?
a. A only
b. B only
c. both A and B
d. neither A nor B
Answers: 3
Engineering, 04.07.2019 18:10, anna22684
Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.
Answers: 2
Engineering, 04.07.2019 18:20, esmemaluma00
Find the minimum film thickness for a journal bearing with the data below. shaft diameter, d-50 mm, clearance ratio, cdratio? 0.001, shaft speed, n 2000 rpm; bearing length. i 200 mm; eccentricity ration, ? -0.55. ( note, cdratio-ca/d) the minimum film thickness is um
Answers: 2
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
A technician is setting up a lab scope to measure a sensor. Technician A says that the vertical volt...
Mathematics, 11.05.2021 14:00
Mathematics, 11.05.2021 14:00
Mathematics, 11.05.2021 14:00
English, 11.05.2021 14:00
Biology, 11.05.2021 14:00
Mathematics, 11.05.2021 14:00