Engineering, 05.02.2021 21:20 carafaith02
Consider a cylinder of height h, diameter d, and wall thickness t pressurized to an internal pressure Po (gauge pressure, relative to the external pressure). The cylinder consists of material with Young’s modulus E, Poisson’s ratio ν, and density rho. Derive expressions for the axial and hoop strains of the cylinder wall in terms of the can dimensions, properties, and internal pressure. You may assume plane stress conditions. Assume a strain gage is bonded to the cylinder wall surface in the direction of the hoop strain. The strain gage has nominal resistance R0 and a Gage Factor GF. It is connected in a Wheatstone bridge configuration where all resistors have the same nominal resistance; the bridge has an input voltage Vin. (The strain gage is bonded and the Wheatstone bridge balanced with the vessel already pressurized.)
Required:
Develop an expression for the voltage change ΔV across the bridge if the cylinder pressure changes by ΔP.
Answers: 2
Engineering, 04.07.2019 18:10, sarahgrindstaff123
Afluid flows with a velocity field given by v=(x/t)i.. determine the local and convective accelerations when x=3 and t=1.
Answers: 2
Engineering, 04.07.2019 18:10, keigleyhannah30
Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.
Answers: 3
Engineering, 04.07.2019 18:10, DestyHilBan1183
Adouble-strand no. 60 roller chain is used to transmit power between a 13-tooth driving sprocket rotating at 300 rev/min and a 52-tooth driven sprocket. a) what is the allowable horsepower of this drive? b) estimate the center-to-center distance if the chain length is 82 pitches. c) estimate the torque and bending force on the driving shaft by the chain if the actual horsepower transmitted is 30 percent less than the corrected (allowable) power.
Answers: 3
Consider a cylinder of height h, diameter d, and wall thickness t pressurized to an internal pressur...
Biology, 21.07.2019 19:30
Social Studies, 21.07.2019 19:30
Business, 21.07.2019 19:30