Engineering, 04.02.2021 06:30 abosse144

What can be used to relieve stress in a weld.

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 19:30, 10040813

When using the ohmmeter function of a digital multimeter, the leads are placed in what position relative to the component being tested? a. parallel b. control c. series d. line

Answers: 3

continue

Engineering, 04.07.2019 18:10, koolgurl2003

Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.

Answers: 1

continue

Engineering, 04.07.2019 18:20, karatsgrande3772

Determine the damped natural frequencies and the steady state response of a decoupled damped forced two degrees of freedom system. 10ä1 + 2q1 20q1 10 cos t; 10q2 +4q2 + 40q2 10 cos t

Answers: 3

continue

Engineering, 04.07.2019 18:20, cristykianpour

Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?

Answers: 2

continue

You know the right answer?

What can be used to relieve stress in a weld....