subject
Engineering, 01.02.2021 22:20 anniebear

From consecutive aerialphotos of traffic along a highway, one observes that there are ten cars per kilometer with 0 velocity (they are parked), forty cars per kilometer traveling at 15 km/hr and twenty cars per kilometer traveling at 30 km/hr. a) If one were to measure these speeds at a stationary point on the highway, determine the values that would be measured for i) time mean speed, and ii) the mean speed that relates flow to density. Compare these with the value of space mean speed over the highway and comment on the difference.
b) Under what condition(s) are measured values of time mean speed and space mean speed equal

ansver
Answers: 3

Other questions on the subject: Engineering

image
Engineering, 04.07.2019 18:10, koolgurl2003
Apump is used to circulate hot water in a home heating system. water enters the well-insulated pump operating at steady state at a rate of 0.42 gal/min. the inlet pressure and temperature are 14.7 lbf/in.2, and 180°f, respectively; at the exit the pressure is 60 lbf/in.2 the pump requires 1/15 hp of power input. water can be modeled as an incompressible substance with constant density of 60.58 lb/ft3 and constant specific heat of 1 btu/lb or. neglecting kinetic and potential energy effects, determine the temperature change, in °r, as the water flows through the pump.
Answers: 1
image
Engineering, 04.07.2019 18:20, hayleymckee
Steam enters a converging nozzle at 3.0 mpa and 500°c with a at 1.8 mpa. for a nozzle exit area of 32 cm2, determine the exit velocity, mass flow rate, and exit mach number if the nozzle: negligible velocity, and it exits (a) is isentropic (b) has an efficiency of 94 percent
Answers: 2
image
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
image
Engineering, 04.07.2019 19:10, jimena15
10 kg of co2 is initially contained at 400 kpa and 300 k. the gas constant for carbon dioxide is 189 j/lkg k) and has a specific heat ratio, k, of 1.289. isentropic expansion then occurs until the pressure is 200 kpa. a) determine the initial volume of co2 in m. b) determine the final temperature in k. c) determine the work done by the system during the expansion kl.
Answers: 2
You know the right answer?
From consecutive aerialphotos of traffic along a highway, one observes that there are ten cars per k...

Questions in other subjects:

Konu
Social Studies, 08.12.2021 06:00
Konu
Mathematics, 08.12.2021 06:00
Konu
Chemistry, 08.12.2021 06:00