Engineering, 01.02.2021 07:30 amberwithnell12512

Use the diagram to determine the voltage at the load after calculating the voltage drop of the wire. Ra = 0.222
120 V
120 V
120 V
120 V
M
0.5 HP
100 W
100 W
75 W
EG
120 V
Rb = 0.222
Note: R and R, represent the resistance of the wire. The 120 volts of the motor and lamps is their rated voltage and
not the actual voltage.

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 04.07.2019 12:10, Ryantimes2

On a average work day more than work place firs are reorted

Answers: 1

continue

Engineering, 04.07.2019 16:10, TheOriginalMeyah

An electrical motor raises a 50kg load at a construct velencity .calculate the power of the motor, if it takes 40sec to raise the load through a height of 24m(take g =9.8n/g)

Answers: 2

continue

Engineering, 04.07.2019 18:10, caitlynnpatton1208

Water in a partially filled large tank is to be supplied to the roof top, which is 8 m above the water level in the tank, through a 2.2-cm-internal-diameter pipe by maintaining a constant air pressure of 300 kpa (gage) in the tank. if the head loss in the piping is 2 m of water, determine the discharge rate of the supply of water to the roof top in liters per second.

Answers: 3

continue

You know the right answer?

Use the diagram to determine the voltage at the load after calculating the voltage drop of the wire....