Task 2 - Design a leaflet for promoting the 3D CAD modelling Your supervisor would like to promote the 3D CAD models to Product Design and
Development Department. You are asked to design an A3 sized leaflet for the promotion
use. The topic is "How the 3D CAD modelling can improve the design process?".
This provides evidence for [M3]
in Customers perspective

Aflywheel accelerates for 5 seconds at 2 rad/s2 from a speed of 20 rpm. determine the total number of revolutions of the flywheel during the period of its acceleration. a.5.65 b.8.43 c. 723 d.6.86

Afull journal bearing has a journal diameter of 27 mm, with a unilateral tolerance of -0.028 mm. the bushing bore has a diameter of 27.028 mm and a unilateral tolerance of 0.04 mm. the l/d ratio is 0.5. the load is 1.3 kn and the journal runs at 1200 rev/min. if the average viscosity is 50 mpa-s, find the minimum film thickness, the power loss, and the side flow for the minimum clearance assembly.

Draw the engineering stress-strain curve for (a) bcc; (b) fcc metals and mark important points.