![subject](/tpl/images/cats/User.png)
Engineering, 29.01.2021 01:10 haylee1468
Kenma come get kuroo please
![ansver](/tpl/images/cats/User.png)
Answers: 3
![](/tpl/images/ask_question.png)
![](/tpl/images/ask_question_mob.png)
Other questions on the subject: Engineering
![image](/tpl/images/cats/User.png)
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:10, 0436500
Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 18:20, annette211pdd8v9
For a gate width of 2 m into the paper, determine the force required to hold the gate abc at its location.
Answers: 1
![image](/tpl/images/cats/User.png)
Engineering, 04.07.2019 19:10, gabigalvis1091
What is the main objective of using reheat rankine cycle?
Answers: 3
You know the right answer?
Kenma come get kuroo please...
Questions in other subjects:
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/informatica.png)
Computers and Technology, 29.05.2020 02:02
![Konu](/tpl/images/cats/mat.png)
Mathematics, 29.05.2020 02:02
![Konu](/tpl/images/cats/en.png)
![Konu](/tpl/images/cats/mat.png)
![Konu](/tpl/images/cats/mat.png)
Mathematics, 29.05.2020 02:02
![Konu](/tpl/images/cats/mat.png)
Mathematics, 29.05.2020 02:03
![Konu](/tpl/images/cats/mat.png)
Mathematics, 29.05.2020 02:03