Engineering, 27.01.2021 20:00 fionatetreault8634

Two previously undeformed rod-shaped specimens of copper are to be plastically deformed by reducing their cross-sectional areas. One has a circular cross section, and the other has a rectangular cross section. During deformation, the circular cross section is to remain circular, and the rectangular cross section is to remain rectangular. Their original and deformed dimensions are as follows: Circular (diameter, mm) Rectangular(mm)
Original dimensions 18.0 20 x 50
Deformed dimension 15.9137 x55.1

Required:
Which of these specimens will be the hardest after plastic deformation, and why?

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 03.07.2019 14:10, makaylashrout77

Amass of 1.5 kg of air at 120 kpa and 24°c is contained in a gas-tight, frictionless piston-cylinder device. the air is now compressed to a final pressure of 720 kpa. during the process, heat is transferred from the air such that the temperature inside the cylinder remains constant. calculate the boundary work input during this process.

Answers: 2

continue

Engineering, 03.07.2019 14:10, bryneosburn

Line joining liquid phase with liquid and solid phase mixture is known as: a) liquidus b) solidus c) tie line d) none of the mentioned

Answers: 2

continue

Engineering, 03.07.2019 23:20, abbz13

Two technicians are discussing the intake air temperature (iat) sensor. technician a says that the computer uses the iat sensor as a backup to the engine coolant temperature (ect) sensor. technician b says that the powertrain control module (pcm) will subtract the calculated amount of fuel if the air measures hot. who is correct

Answers: 3

continue

Engineering, 04.07.2019 18:20, kodyclancy

Aquick transition of the operating speed of a shaft from its critical speed will whirl amplitude. (a) increase (b) limit (c) not affect (d) zero

Answers: 2

continue

You know the right answer?

Two previously undeformed rod-shaped specimens of copper are to be plastically deformed by reducing...