Engineering, 24.01.2021 23:40 cgattis6935
The pressure difference between two points along a horizontal pipe, through which
water is flowing, is 1.4cm of mercury. If due to non-uniform cross-section, the speed of flow
of water at the point of greater cross-section is 60cm/sec .Calculate the speed at the other
part.
Answers: 2
Engineering, 04.07.2019 18:10, lillygrl100
For the closed feedwater heater below, feedwater enters state 3 at a pressure of 2000 psia and temperature of 420 °f at a rate of ix10 ibhr. the feedwat extracted steam enters state 1 at a pressure of 1000 psia and enthalpy of 1500 btu/lbm. the extracted er leaves at an enthalpy of 528.7 btu/lbm steam leaves as a saturated liquid. (16) a) determine the mass flow rate of the extraction steam used to heat the feedwater (10) b) determine the terminal temperature difference of the closed feedwater heater
Answers: 3
Engineering, 04.07.2019 18:10, xboxdude06
Slip occurs via two partial dislocations because of (a) the shorter path of the partial dislocation lines; (b) the lower energy state through partial dislocations; (c) the charge balance.
Answers: 1
Engineering, 04.07.2019 18:20, cristykianpour
Describe one experiment in which the glass transition temperature and melting temperature of a totally amorphous thermoplastic material can be determined. show the relevant experimental results in a diagram which should be properly annotated with the two temperatures clearly marked. what is likely to happen to the curve in the diagram if the amorphous polymer is replaced by a thermosetting type?
Answers: 2
The pressure difference between two points along a horizontal pipe, through which
water is flowing,...
Mathematics, 16.12.2019 12:31
Biology, 16.12.2019 12:31
Mathematics, 16.12.2019 12:31
Mathematics, 16.12.2019 12:31
Mathematics, 16.12.2019 12:31
Mathematics, 16.12.2019 12:31
Mathematics, 16.12.2019 13:31