Rita is trying to decide which branch of engineering she wants to study in college. Which branch of engineering best fits Rita's interests?

-chemical engineering
-biomedical engineering
-electrical engineering
-mechanical engineering

Aplate clutch has a single pair of mating friction surfaces 250-mm od by 175-mm id. the mean value of the coefficient of friction is 0.30, and the actuating force is 4 kn. a) find the maximum pressure and the torque capacity using the uniform-wear model. b) find the maximum pressure and the torque capacity using the uniform-pressure model.

To design a steam turbine to produce 12,000 hp power. a engineer comsiders using a steady state stean low st 1160fr and engineer considers using a steady state steam flow at 1160°r and 450 psia to drive this steam turbine. the exhaust of the steam is cooled by the lake (vacuum). heat losing to the surroundings is measured at a rate of 555.55 btu/s. (a) sketch the system with the given conditions. (b) neglecting kinetic and potential energy changes from inlet to exit, determine the volumetric flow rate of the steam at the inlet, (ft'/hr). must clearly show unit conversions at crtical terms.

Apipe of diameter 200 mm (constant) carrying water with an 5 mis and total head is density 1000 kg/m ) with velocity tpward slope. at a certain point, where the elevation is 5 m above a datum, the 21.5 m. a) determine the pressure of the pipe at 5m elevation. determine the pressure at elevation 10m (above same datum) if the of total head at 5m elevation.