Engineering, 21.01.2021 23:20 tonydeanfbg8706

Dr. DeVleming has decided to feed her dogs a raw-food diet, consisting of raw chicken C, butternut squash S, potatoes P, and eggs E. She knows the macronutrient ratio (grams per serving) of each ingredient: (macronutrient ratios written as ingredient [grams carbohydrates
grams protein
grams fat])
C = [2 18 2] S = [18 4 1] P= [24 3 0] E = [6 5]
A) Given the different exercise and health needs of her dogs, can she achieve any desired macronutrient ratio of carbs : protein : fat with some combination of these ingredients?
B) What does you answer to (a) say about the span of the given vectors?
C) Oh no! She has run out of butternut squash. Can she still achieve any desired macronutrient ratio? What if she runs out of any other ingredient?

Answers: 3

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:10, anna22684

Water at 70°f and streams enter the mixing chamber at the same mass flow rate, determine the temperature and the quality of the exiting stream. 0 psia is heated in a chamber by mixing it with saturated water vapor at 20 psia. if both streams enters the mixing chamber at the same mass flow rate, determine the temperature and the quality of the existing system.

Answers: 2

continue

Engineering, 04.07.2019 18:10, alyssabailey7545

Give heat transfer applications for the following, (i) gas turbines (propulsion) ) gas turbines (power generation). (iii) steam turbines. (iv) combined heat and power (chp). (v) automotive engines

Answers: 1

continue

Engineering, 04.07.2019 18:10, samanthabutryn

Which one from below is not one of the reasons of planning failures? (clo3) a)-planner is careless. b-planner spend less time in the field but more time on the desk c)-planner is not qualified d)-planner does not have sufficient time to properly plan

Answers: 3

continue

Engineering, 04.07.2019 18:10, 0436500

Aturning operation is performed with following conditions: rake angle of 12°, a feed of 0.35 mm/rev, and a depth of cut of 1.1 mm. the work piece is aluminum alloy 6061 with t6 heat treatment (a16061-t6). the resultant chip thickness was measured to be 1.0 mm. estimate the cutting force, fc. use shear stress of 207 mpa and coefficient of friction on the tool face of 0.6.

Answers: 1

continue

You know the right answer?

Dr. DeVleming has decided to feed her dogs a raw-food diet, consisting of raw chicken C, butternut s...