Engineering, 21.01.2021 23:00 kevinbazalar

A tensile specimen with initial section A0=129 mm2 carries a maximum load of 53378 N. and the initial section A0 has been reduced by 40% at that time. A second specimen of identical material and starting dimensions was pulled until the true strain (Ɛt) was half the magnitude of the strain hardening exponent. What load would be required to reach this condition?

Answers: 1

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 03:10, lauriepdx17

What precautions should you take to prevent injuries when dealing with heavy loads?

Answers: 1

continue

Engineering, 04.07.2019 18:10, ashleybaber4966

If a particle moves along a path such that r : (3 sin t) m and ? : 2t rad, where t is in seconds. what is the particle's acceleration in m/s in 4 seconds? a)- 16.43 b)- 16.29 c)- 15.21 d)- 13.79

Answers: 1

continue

Engineering, 04.07.2019 18:10, redrosesxx

Water at 55c flows across a flat plate whose surface temperature is held constant at 95c. if the temperature gradient at the plate's surface for a given value of x is 18 c/mm, find a) local heat transfer coefficient. b) heat flux

Answers: 3

continue

Engineering, 04.07.2019 18:10, Candi9697

A-mn has a cubic structure with a0 0.8931 nm and a density of 7.47 g/cm3. b-mn has a different cubic structure, with a0 0.6326 nm and a density of 7.26 g/cm3. the atomic weight of manganese is 54.938 g/mol and the atomic radius is 0.112 nm. determine the percent volume change that would occur if a-mn transforms to b-mn.

Answers: 2

continue

You know the right answer?

A tensile specimen with initial section A0=129 mm2 carries a maximum load of 53378 N. and the initia...