Engineering, 21.01.2021 22:40 soleil26

Please help ( true or false questions)69. Secure the work with clamps or the vise. _70. Check to see the sanders switch is in the on position before plugging in
-71. Replace sandpaper after plugging into the electrical outlet.
72. Tuming offthe dust collection system.
73. Don't force the machine. Use only the weight of the machine to do the
sanding
74. Watch where the cord is so you get it caught in the machine.
75. Don't put the machine down until it stops moving.
76. Pretend the sander is a race car and has to be revved up so you look cool.
Saber Saw Test
77. Wear safety glasses.
_78. Make all adjustments with the power cord plugged in.
79. Check to see that the switch is off before plugging in the machine.
80. Overload the machine by cutting too fast.
Meeting in "General
81. Keep fingers and power cords a safe distance from the blade.
RS
82. Use a four inch safety margin.
83. Make relief cuts to avoid tuming the blade too sharp.

Answers: 2

Show answers

Other questions on the subject: Engineering

Engineering, 04.07.2019 18:20, rjone8429

Asimple rankine cycle uses water as the working fluid. the water enters the turbine at 10 mpa and 480c while the condenser operates at 6 kpa. if the turbine has an isentropic efficiency of 80 percent while the pump has an isentropic efficiency of 70 percent determine the thermal efficiency

Answers: 1

continue

Engineering, 06.07.2019 03:10, kturvey225

Consider a 1.2 meter high and 2 meter wide glass window whose thickness is 6 mm and thermal conductivity is 0.78 w/m °c. the room temperature is maintained at 24 °c, while the outdoor temperature is -5 °c. the convective heat transfer coefficients on the inner and outer surfaces of the window are 10 w/m2 °c and 25 w/m2 °c respectively. (a) draw the thermal resistance network, etermine the steady rate of heat transfer t e glass window (c) determine the temperature of the inner surface of the window

Answers: 3

continue

Engineering, 06.07.2019 03:10, iiisavageoreo

Two slings are used to lift a girder of length l and uniform weight per unit length. what is the best position for the slings if the bending moment due to the weight of the girder is to be kept to a minimum?

Answers: 2

continue

Engineering, 06.07.2019 05:10, cedricevans41p4j3kx

It has been stated that the quality of the sheared edges can influence the formability of sheet metals. explain why

Answers: 3

continue

You know the right answer?

Please help ( true or false questions)69. Secure the work with clamps or the vise. _70. Check to se...